First Shots: FNX9 Pistol

Renown Browning Hi Power Expert - Stephen A. Camp

Moderator: carlson1

First Shots: FNX9 Pistol

Postby Stephen A. Camp » Fri Apr 22, 2011 12:59 pm

Hello. I recently tried out two different FNX9 9mm pistols. FNX is the successor to Fabrique National's FNP-handgun series. This polymer-framed, double-action semiautomatic sports frame-mounted, ambidextrous thumb safety levers, which double as decockers, and the pistol does permit Condition One ("cocked-and-locked") Carry for those preferring that option. Unlike the Hi Power, the FNX-line is manufactured in the USA.

The FNX9 has a stainless-steel slide-and-barrel assembly. On one pistol both were left "in the white" for a two-tone appearance. The slide/barrel assembly had been somehow coated black on the pistol. (Other than "looks", these pistols performed equivalently.)

Image
Here is the dark version of the FNX9 semiautomatic pistol. The thumb safety ("on safe" in this picture) can be applied whether the hammer is at full-cock, in the "hammer drop position" (as shown in the photo) or fully foward. The hammer can also be cocked with the thumb safety applied and the slide can be hand-cycled as well. The only time that the pistol must be off-safety is to fire it! Certainly, it can be carried with the hammer down for a DA first-shot and the safety off, but for those preferring to do so, the safety can be applied and disengaged during presentation as is done by practicioners of the single-action autoloader. Barrel length is 4".

FN advises that these pistols are sighted-in for a dead-on hold at 20 yards.

Image
This 15-shot group was fired in three series of 5-shots, the first of each being fired double-action. The two shots at 6 o'clock and one at eleven o' clock are those hits. The remaining twelve were fired single-action and are in about a 2" group. The three double-action shots spread the group to approximately 3 1/2" or so. Ammunition used was Winchester 127-gr. Ranger +P+.

I have no doubt that the pistol is capable of better inherent mechanical accuracy and the spread is due to the "human factor"....mine!

Image
Primer strikes were positive and reasonably well-centered. There were no failures to fire whatsoever in over 1000 shots fired in 5 separate range visits, including this one.

Previous to todays shooting session, this particular FNX9 had digested roughly 700 shots of various commercial ammuntion. With today's 320 shots, that count is now over a thousand with no failures of any sort.

In my opinion, the pistol has the potential as a viable choice for those desiring a reliable and lightweight polymer-framed autoloader for either home defense, concealed carry or both. (The pistol is larger than some expressly intended for clandestine carrying, but this pistol can be concealed with little effort and appropriate clothes selection.)

There are features I really like with the FNX9, but it has some I find distasteful as well. For those interested in a more detail and lengthy report, follow the link below:

http://www.hipowersandhandguns.com/taking_a_look_at_the_fnx_9mm_pistol.htm

Best to all and good shooting.
Stephen A. Camp
Moderator
 
Posts: 22
Joined: Sun Jun 06, 2010 6:53 pm

Re: First Shots: FNX9 Pistol

Postby Stephen A. Camp » Fri Apr 29, 2011 11:17 am

Hello. I just completed another shooting session with the FNX9 for those who might be interested:

http://www.hipowersandhandguns.com/shoo ... ations.htm

Best.
Stephen A. Camp
Moderator
 
Posts: 22
Joined: Sun Jun 06, 2010 6:53 pm

Re: First Shots: FNX9 Pistol

Postby BobCat » Fri Apr 29, 2011 12:46 pm

Thanks for the writeups!

I'll keep my Highpowers and CZ75B though.
Retractable claws; the *original* concealed carry
BobCat
Senior Member
 
Posts: 799
Joined: Wed Dec 29, 2004 3:33 pm
Location: East Bernard, TX

Re: First Shots: FNX9 Pistol

Postby saltydog452 » Fri Apr 29, 2011 6:02 pm

Thank you Stephen.

salty
saltydog452
Senior Member
 
Posts: 242
Joined: Sun May 23, 2010 3:52 pm


Return to Camp's Corner

Who is online

Users browsing this forum: No registered users and 1 guest