Handloads for 6.5CM - is this bad?

[KC5AV]

I was working with a friend to set up some test loads for my new Bergara B14 HMR. We started with published load data on a few different powders. Looking at the cases after firing, I’m wondering if there’s a problem.
The bulets were Hornady 129gr SST. This case was loaded with 35gr and 35.5gr of Varget with a CCI 450 primer. 35 grains is the published starting point for Varget.
OAL were all within published specs.

[SQLGeek]

Looks like the ejector might be taking a swipe out of the brass, possibly when you're closing the bolt. Is this doing it on commercial ammo?

You might try chambering a round and then ejecting the round without firing it to confirm when this is happening (if you haven't already).

[Beiruty]

There is defect in the bolt head. It needs to be corrected. This is not what you see as pressure sign.

[KC5AV]

I wondered if it might be something with the bolt, but I’m not seeing the same thing on commercial loads.

[Beiruty]

I wondered if it might be something with the bolt, but I’m not seeing the same thing on commercial loads.

Can you try new brass with your reloads?

[KC5AV]

I’ll try to get some loaded up this weekend.