Can anyone identify these rollers?
Moderators: carlson1, Charles L. Cotton
-
- Senior Member
- Posts in topic: 1
- Posts: 2781
- Joined: Sat Feb 20, 2010 11:48 pm
- Location: Kempner
- Contact:
Re: Can anyone identify these rollers?
If a customer bought me that job.. I would likely make the rollers out of Delrin round stock, bore them and install a bronze bushing. And depending on what I felt the side load would be, use a thrust washer or thrust cylindrical roller bearing
Companion animal Microchips, quality name brand chips, lifetime registration, Low cost just $10~12, not for profit, most locations we can come to you. We cover eight counties McLennan, Hill, Bell, Coryell, Falls, Bosque, Limestone, Lampasas
Contact we.chip.pets@gmail.com
Contact we.chip.pets@gmail.com
Re: Can anyone identify these rollers?
If you need machining to duplicate or modify, contact me
-----------
“Sometimes there is no alternative to uncertainty except to await the arrival of more and better data.” C. Wunsch
“Sometimes there is no alternative to uncertainty except to await the arrival of more and better data.” C. Wunsch